Lehi flashing & penetration referrals

Flashing & Chimney Leak Repair in Lehi, UT

Caulk alone fails fast under Utah's freeze-thaw swings. Connect with an independent Northern Utah County roofer for proper sheet-metal flashing repair.

Why do roof flashing transitions fail so often on Utah homes?

Every time a roof plane intersects a vertical surface—a framed stucco chimney chase, a masonry fireplace chimney, a dormer wall, a skylight curb, or a garage-to-house junction—two different building materials expand and contract at different rates. In Lehi and Northern Utah County, summer daytime highs past 90°F and winter overnight lows in the 20s°F cycle those joints thousands of times over a roof's life. When builders or previous repairers rely on thick beads of roof tar or caulk instead of properly lapped sheet metal, thermal movement tears the sealant open and invites water straight behind the siding or into the attic.

Modern Silicon Slopes and Traverse Mountain homes are especially flashing-heavy. Multi-level elevations, stone-veneer accents, recessed garage roofs, and eyebrow dormers create dozens of linear feet of roof-to-wall intersections. Meanwhile, older brick chimneys in central Lehi, American Fork, and Pleasant Grove frequently suffer from weathered mortar reglets, missing crickets (diverter saddles) on the upslope side, and rusted counterflashing that pulls away during winter freeze-thaw cycles.

What separates real flashing repair from temporary caulking?

  • Step flashing interwoven course by course: Along sloping roof-to-wall intersections, individual L-shaped metal step flashings must interweave with every single shingle course—not one continuous strip nailed through the face.
  • Kickout (diverter) flashing at wall terminations: At the bottom edge where a sloped roof meets a vertical stucco or siding wall, a kickout flashing deflects runoff cleanly into the gutter instead of pouring water behind the exterior cladding.
  • Chimney counterflashing and upslope crickets: Proper masonry chimney repairs cut new reglet grooves into mortar joints to tuck sheet-metal counterflashing over base step flashing, and add or rebuild a metal saddle cricket on wide chimneys to shed snowmelt sideways.
  • Ice-and-water membrane underneath: In Wasatch Front snow zones, sealing roof-to-wall and skylight perimeters with self-adhering polymer-modified bitumen underlayment before reinstalling metal adds vital backup against wind-driven rain and ice backup.

Roofing Repair Lehi connects homeowners with independent Northern Utah County contractors who rebuild sheet-metal flashing correctly rather than smearing temporary mastic. Use our online form to request a local evaluation.

Get a Free Estimate

Areas We Cover in Northern Utah County

Which flashing zones cause the most stubborn leaks in Northern Utah County?

Because water entering a wall or chimney chase can travel down framing cavities before appearing on a first-floor ceiling, independent contractors inspect both roof metal and adjacent wall terminations.

Chimney step, apron, and counterflashing

Rebuilding base step flashing, front apron flashing, and reglet-cut counterflashing on brick or stone chimneys, plus repairing upslope crickets that prevent snowpack pooling.

Roof-to-wall step and kickout flashing

Fixing leaks where porch, garage, or lower living-area roofs abut two-story stucco, brick, or fiber-cement sidewalls—including adding missing kickout diverters.

Skylight and sun-tunnel flashing kits

Diagnosing whether moisture around a skylight comes from failed perimeter flashing, dried glazing seals, or interior condensation, and installing proper step-flashing kits.

Open and woven valley metal repairs

Replacing rusted, bent, or improperly nailed valley metal where steep Silicon Slopes dormers dump concentrated snowmelt and rain.

What factors drive flashing & chimney repair quotes in Lehi, UT?

Flashing ZoneScope Details Verified on SitePricing Basis
Stucco or siding wall tie-insWhether exterior cladding must be carefully opened/re-counterflashed to install step and kickout metalWritten quote after on-site inspection
Masonry vs. framed chimney chaseReglet cutting into brick/stone mortar + cricket framing vs. siding-wrapped metal chase flashingVaries by chimney width and pitch
Skylight flashing vs. unit ageWhether manufacturer flashing kit can be replaced around sound unit or aging curb seal warrants unit replacementConfirmed during roof & interior check
Underlayment & decking conditionReplacing water-stained wall sheathing or roof decking beneath prolonged flashing leaksItemized in contractor's written scope

Roofing Repair Lehi is a referral service and never quotes construction prices. Independent Utah DOPL-licensed contractors provide site-specific written estimates.

Why Use a Referral for Flashing & Chimney Leak Repair?

Metalwork over temporary roof tar

Connect with independent roofers who diagnose missing step flashing, kickout diverters, and failing chimney reglets instead of relying on surface caulk.

Experience with Utah stucco and stone veneer

Northern Utah County homes heavily use stucco and cultured stone wall accents that require careful counterflashing details to stay dry.

Honest masonry vs. roof distinction

If chimney water is actually entering through a cracked concrete crown or porous brick rather than roof flashing, a straightforward roofer tells you clearly.

Zero referral fee for homeowners

Submit your flashing leak details once online and review written contractor quotes with no obligation.

Contact Us Today for a Free Estimate

Seeing stains near a fireplace, dormer wall, or skylight in Lehi? Submit our form to connect with an independent local flashing repair pro.

Get a Free Estimate

Free — no obligations

How do local roofers diagnose and fix flashing leaks?

1. Describe the wall, chimney, or skylight location

Use our estimate form to share which room or exterior junction is leaking and whether the leak happens in heavy rain, snowmelt, or wind.

2. On-site flashing and cladding check

An independent local contractor inspects existing step metal, counterflashing, crickets, kickout diverters, and adjacent siding or masonry.

3. Written metalwork repair scope

Review a clear written quote detailing metal gauge, ice-barrier membrane, shingle tie-in, and any siding or mortar coordination needed.

4. Rebuild, seal, and water-shed check

After verifying the contractor's Utah DOPL license and approving the quote, the crew rebuilds the flashing assembly for long-term drainage.

Roofing Repair Services Available in Lehi, UT

Get a Free Estimate